Instruction manual

Page 15 of 18 pages
7
8
. Install an approx. 23-foot long wing wire between the left-side upper & lower wing panels:
Diagram of
left-side
pair of
wing panels
Note: Each of
the numbers
‘1’ thru ‘12’
on this
diagram
are known
as “Anchor
Numbers”
Anchor Numbers Wire-Routes (Each segment is underlined by a wing-wire COLOR/PATTERN CODE)
1 – 2: Start with a clevis and brass pull-rod at the bottom of the center rear strut, then guide the end of the
wing wire to the top of the center front strut;
2 – 3: Guide the end of the wire from the top of the center front strut > bottom front L-bracket;
3 – 4: From the bottom front L-bracket
> top rear L-bracket;
4 – 1: Top rear L-bracket > bottom of the center rear strut;
1 – 5: Bottom of the center rear strut > top of the outside rear strut;
5 – 6: Top of the outside rear strut > bottom of the outside front strut;
6 – 2: Bottom of the outside front strut > top of the center front strut;
2 – 7: Top of the center front strut > top of the center rear strut;
7 – 8: Top of the center rear strut > bottom of the outside rear strut;
8 – 9: Bottom of the outside rear strut > top of the outside front strut;
9 – 10: Top of the outside front strut > bottom of the center front strut;
10 – 11: Bottom of the center front strut > top front L-bracket;
11 – 12: Top front L-bracket > bottom rear L-bracket;
12 – 7: Bottom rear L-bracket > top of the center rear strut;
7 – 10: Top of the center rear strut > bottom of the center front strut, then end by drawing the wing-wire tight
and using the same attachment process as in #74 to secure the wire’s end to a brass pull-rod and clevis
and to the center front strut. Cut and discard the excess cable.
79. Secure both ends of the left-side wing wires by permanently anchoring each brass pull-rod into its clevis with a few
d
rops of CA adhesive.
(Leading edge)
1
2
3
4
5
6
5
7
8
9
10
11
12
(Leading edge)
12