Instruction manual

Page 12 of 18 pages
61. S
ecure the lower ends of the four(4) cabanes to the fuselage by tightening each of the eight(8) self-locking nuts
i
nside the fuselage.
62. Pointing the shanks of four(4) 12 mm (7/16-inch) bolts toward the center of the
fuselage, insert each bolt fully through the top of each of the four(4) cabanes
and the wing center section’s wooden cabane mounts. Tighten a self-locking
nut onto each of the four(4) bolts at the top of each of the four(4) cabanes [34:57].
63. With the shanks of eight(8) 12 mm (7/16-inch) bolts pointing toward the fuselage,
insert each bolt fully through the top of the four(4) OUTER and four(4) INNER
struts and the top wing’s wooden strut mounts.
64. Place a flat wing-wire anchor on the end of each of the eight(8) bolts projecting
toward the fuselage at the top of each OUTER and INNER strut [35:50].
65. Aim the free end of each flat wing-wire anchor in the direction of the base of the opposite strut (i.e., from the top
of the front strut toward the base of the rear strut, and from the top of the rear strut toward the base of the front
strut). Tighten a self-locking nut onto each of these eight(8) OUTER and INNER strut bolts.
66. Insert two(2) top-rear wing wire mounts and two(2) top-front wing wire mounts into the upper wing and secure
each with CA adhesive [37:29].
Top-rear wire mount. T
op-front wire mount. Secure with CA adhesive.
67. Position two(2) rear wing-cable tubes (each 62mm tall) and two(2) front wing-cable tubes (each 56mm tall) over
their respective top wing-wire mounts. With the shanks of eight(8) 12 mm (7/16-inch) bolts pointing toward
the fuselage, insert and push
each bolt fully through the
two(2) lower holes in each
wing-cable tube and its top
wing-wire mount. Tighten a
self-locking nut onto each of
these eight(8) bolts. [38:09].
Front & rear INNER
struts & flat
wing anchors on the
left upper wing panel.
Front & rear OUTER
struts & flat
wing anchors on the
left upper wing panel.