Instruction manual

Page 11 of 18 pages
55. A
ttach four(4) large L-shaped wing-wire anchors to the top of the lower wing near each side of the fuselage by
i
nserting two(2) 12 mm (7/16-inch) wood screws through each wing anchor and driving them securely into the
predrilled holes. Apply CA adhesive to harden the holes in the wood where the screws are inserted. [32:31].
Approximate
hole locations
as viewed at
the right side
of the fuselage.
Two(2) of the
large L-brackets
installed on the
wing at the left
side of the
fuselage.
56. Guide the end of each aileron servo’s extension cable out of the precut hole in the bottom of each top wing panel.
5
7. Insert and center the “22 mm diameter by 665 mm long” upper wing-joiner tube in the upper wing’s center section.
Insert and center the 23.5 cm (9 1/4-inch ) long carbon-fiber alignment shaft through the predrilled holes at the rear
of the upper wing’s center section.
58. Apply a dry lubricant (graphite or equivelant) to the
upper wing’s joiner tube. Slide the left and right upper
wing panels onto the upper wing joiner tube and the
carbon-fiber alignment shaft until each wing panel’s
root rib just-touches the corresponding outer rib of the
upper wing’s center section.
59. Attach four(4) large L-shaped wing-wire anchors to
the bottom surface of the upper wing panels by
inserting two 12 mm (7/16-inch) wood screws through
each wing anchor and driving them securely into the
predrilled holes. Apply CA adhesive to harden the
holes in the wood where the screws are inserted
[33:25].
60. Position the upper wing above the cabanes, then
carefully guide each preinstalled wooden wing strut
and cabane mount fully into each corresponding strut
and cabane [34:39]. Attach a servo Y-connector to the free ends of the two(2) servo extension cables.
5½-inches
5-inches
7/8
-
inch
5/16
-
inch (8 mm)
6 3/4-inches
2 1/2-
inches
(Leading edge)
(Trailing edge)
20 mm
(13/16-inch)