Manual

Handling Modification
13 06.01GB
5.8.2 Unloading the pistol, magazine
empty, slide open
Procedure:
1. Keep the muzzle of the pistol pointed in a safe
direction.
2. Actuate magazine catch 24 and remove the
magazine (see Fig. 3).
3. Check visually and manually with a tool that
the round was ejected and that no other round
is chambered.
4. Actuate slide catch lever 17.
Slide 4 is impelled forward.
5. Press decocking lever 38 down (Not applicable
to DAO pistols).
6. Check the load state of the magazine.
The pistol is unloaded and decocked.
6 Modification of the pistol
The modification of the operating side is limited to
the repositioning of the magazine catch 24.
6.1 Repositioning the magazine catch
Procedure:
1. Push in magazine catch 24 until it projects
slightly on the opposite side (see Fig. 5).
2. Push the straightened end of a paper clip into
the opening of the magazine catch.
The sear of the magazine catch stop 25 is
released (see Fig. 6).
WARNING!
Pistol is loaded
May lead to death or severe injuries
• The pistol must not be put down and out of
your hand until the magazine is removed and
the pistol is unloaded.
WARNING!
Pistol has not been cleaned sufficiently
May lead to death or severe injuries and
damage to the pistol
• The pistol must be cleaned after every
shooting session (see Section 8.3).
WARNING!
Uncontrolled discharge of shot
May lead to death or severe injuries
• Prior to modifying the pistol, make sure that it
is unloaded and that the magazine is
removed
(see Section 5.8).
Fig. 5, Pushing in the magazine catch (illustration without trigger)