Manual

Maintenance
17 06.01GB
8.1.1 Stripping the slide
Procedure:
1. Push recoil spring guide 2 forward and to the
side, raise it carefully and remove the recoil
spring 3 with the recoil spring guide from the
slide 4.
2. Remove barrel 1 from the slide 4.
Note:
• This level of stripping is sufficient to allow a
thorough cleaning after shooting.
• Further dismantling of the pistol may only be
carried out by qualified armourers and
gunsmiths.
8.2 Disassembly of the magazine
Procedure:
1. Thump up floorplate insert 47 through the
notch in the magazine floor plate 50 by means
of a pin punch (diameter 3 mm or 4 mm).
2. Push the magazine floor plate forward and pull
it off.
CAUTION!
Slide and recoil spring unit are only
connected loosely with each other
May lead to injuries and damage to the pistol
• The recoil spring 3 is cocked.
Uncontrolled removal of recoil spring guide 2
can cause it and the recoil spring 3 to jump
away. When stripping, control decompression
of the preloaded recoil spring 3 with your
hand.
Fig. 14
Fig. 15
2.
1a.
324
1b.
2.
1.
14
CAUTION!
Magazine spring is compressed
May lead to injuries and damage to the pistol
• Do not carry out any work on the pistol near
your face and hold magazine with the
magazine floor plate pointing downwards.
Fig. 16, Magazine
2.
50
1.