Manual

Maintenance
1606.01 GB
8 Pistol maintenance
8.1 Stripping the pistol
Procedure:
1. Unload the pistol (see Section 5.8).
2. Draw back slide 4 to the stop and arrest it in
the open position by thumbing up the slide
catch lever 17.
3. Check that no round is chambered
(see Fig. 4).
4. Clasp the grip and locking piece with the right
hand, draw back slide 4 slightly to disengage
slide catch lever 17. Afterwards, allow the slide
4 to glide forward by approx. 3 mm, until the
notch 4b at slide 4 corresponds to the nose at
the slide catch lever 17. Push in slide catch
lever 17 from the right and pull it out from the
left.
5. Hold slide 4 firmly and allow it to glide forward,
until the recoil spring 3 is decocked.
6. Now slip the complete assembly (slide 4,
barrel 1, recoil spring 3 and recoil spring
guide 2) forward and off the frame.
WARNING!
Pistol is ready to fire
May lead to death or severe injuries
• The magazine must be removed from the
pistol.
• Before stripping your pistol for cleaning,
ensure once again that it is unloaded
(see Section 5.8).
• Do not grasp slide 4 with your fingers.
Fig. 11
1.
2.
174
Fig. 12
Fig. 13
17 44b
4