Manual

Modification
1206.01 GB
4. Actuate slide catch lever 17.
Slide 4 is impelled forward.
5. Press decocking lever 38 down (Not applicable
to DAO pistols).
6. Check the load state of the magazine.
The pistol is unloaded and decocked.
6 Modification of the pistol
The modification of the operating side is limited to
the repositioning of the magazine catch 24.
6.1 Repositioning the magazine catch
Procedure:
1. Push in magazine catch 24 until it projects
slightly on the opposite side (see Fig. 5).
2. Push the straightened end of a paper clip into
the opening of the magazine catch.
The sear of the magazine catch lock 25 is
released (see Fig. 6).
3. Remove magazine catch lock 25.
4. Remove magazine catch 24 and insert it from
the desired operating side (see Fig. 7).
WARNING!
Pistol has not been cleaned sufficiently
May lead to death or severe injuries and
damage to the pistol
• The pistol must be cleaned after every
shooting session (see Section 8.3).
WARNING!
Uncontrolled discharge of shot
May lead to death or severe injuries
• Prior to modifying the pistol, make sure that it
is unloaded and that the magazine is
removed
(see Section 5.8).
Fig. 5, Pushing in the magazine catch (illustration without trigger)
Fig. 6, Releasing the magazine catch lock (illustration without trigger)