Manual

7.3 Assembling the pistol
Procedure
1. Check that there is no foreign matter inside the pistol.
2. Push the grip plate back on from below until it notches
home.
3. Place the barrel 1 with the control cam in the slide 4 from
below.
When recoil spring 3 is inserted into slide 4, it becomes pre-
loaded. If the recoil spring guide 2 is not carefully installed
in slide 4, it can fly out, together with the recoil spring 3, and
injure you or someone in your vicinity.
4. Insert recoil spring guide 2 with recoil spring 3 into slide 4.
5. Push the entire system onto the frame 13 from the front until
it is correctly on rear side positioned.
6. Push the slide catch lever 17 into position horizontally from
the left until it rests against the slide 4.
– 17 –
sig pro™
Maintenance
Fig. 14, Pistol dismantled for cleaning
SIGARMS SIGPRO OM 6/6/01 3:33 PM Page 17