Manual

Unloading:
The only way to be certain that a rifle is unloaded is to check it visually. Place
the safety in the center position (See Figure 1B, page 8), open the bolt, remove
the magazine and look in the chamber to make sure there is not a cartridge pre-
sent. This is essential for your safety and the safety of others.
Disassembly
Before you disassemble the rifle, make sure that it is unloaded.
Removing the bolt:
1. Make sure the rifle is unloaded.
2. Put the safety lever in the cen-
ter position.
3. Open the bolt and draw it back,
to the stop.
4. Press the bolt release/stop lever on
the left side of the receiver and
extract the bolt from the receiver by
pulling it rearward (See Figure 8).
Removing the magazine:
1. Make sure the rifle is unloaded.
2. Press forward firmly on the magazine catch located in the front of the trigger guard.
Removing the stock:
1. Make sure the rifle is unloaded.
2. Remove the magazine.
3. Remove the bolt.
4. Remove the rear and front stock
retention screws using the wrench
provided and remove the floor
plate and integral trigger housing
(See Figure 9).
5. Lift the action out of the stock
(See Figure 10).
12
Figure 8
WARNING
Before performing any cleaning or maintenance, make sure the rifle
is completely unloaded. This includes the magazine and chamber.
Figure 10
Figure 9