Manual

3.15 Function check

The function check described below is to be made after every stripping.

1. Unload per Section 3.3;

2. Make sure that bolt handle is engaged in correct position;

3. Functions:

a. Safety lever set to “S”, carry out loading movement, pull the

trigger:



The hammer must not trip, the trigger must be blocked;

b. Safety lever set to “1”, pull the trigger and hold it:



The hammer must trip

Carry out loading movement with trigger being pulled:



The hammer must not trip;

Release the trigger and pull it again:



The hammer must trip;

c. Loading movement:



Safety lever on “1”: verify several times that there is a

discernible pressure point;

4. Insert empty magazine and check firm seating;

5. Bolt catch;

a. Carry out loading movement;



The bolt must be retained in the rear position;

b. Push up the bolt catch:



The bolt must run forward;



Check engagement of folded butt, pull the trigger and

put the weapon on safe.