Manual

Maintenance
1607.01 GB
Procedure:
1. Push recoil spring guide 2 forward, raise it
carefully and remove the recoil spring 3 with
the recoil spring guide 2 from the slide 4.
2. Remove the recoil spring from the recoil spring
guide.
3. Remove barrel 1 from the slide 4.
Note:
• This level of stripping is sufficient to allow a
thorough cleaning after shooting.
• Further dismantling of the pistol may only be
carried out by qualified armourers and
gunsmiths.
7.2 Disassembly of the magazine
Procedure:
1. Thump up floorplate insert 55 through the
notch in the magazine floor plate 54 by means
of a pin punch (diameter 3 mm or 4 mm).
2. Push the magazine floor plate forward and pull
it off.
Fig. 10
Fig. 11
1a.
4
1b.
2
3
2.
1.
1
CAUTION!
Magazine spring is compressed
May lead to injuries and damage to the pistol
• Do not carry out any work on the pistol near
your face and hold magazine with the
magazine floor plate pointing downwards.
• When removing the magazine spring, decock
it slowly and with care.
Fig. 12, Magazine
2.
1.
54