Manual

Handling Sight
13 07.01GB
5.8.2 Unloading the pistol, magazine
empty, slide open
Procedure:
1. Keep the muzzle of the pistol pointed in a safe
direction.
2. Press magazine catch 43 down and remove
magazine (see Fig. 2).
3. Check visually and manually with a tool that
the round was ejected and that no other round
is chambered.
4. Press slide catch lever 18 down. Slide 4 is
impelled forward.
5. Press decocking lever 40 down (not applicable
to DAO/DAK pistols).
6. Check the load state of the magazine.
The pistol is unloaded and decocked.
6 Sight correction
6.1 Sight correction for windage
6.1.1 Shifting the rear sight
Note:
• A special tool is required for this purpose (see
Section 6.4).
Shifting the rear sight 6 by 0.5 mm to the right
alters the point of impact to the right by approx. 8
cm at a 25 m range.
6.1.2 Shifting the front sight
Note:
• A special tool is required for this purpose (see
Section 6.4).
Shifting the front sight 5 by 0.5 mm to the left alters
the point of impact by approx. 8 cm to the right at
a 25 m range.
WARNING!
Pistol is loaded
May lead to death or severe injuries
• The pistol must not be put down and out of
your hand until the magazine is removed and
the pistol is unloaded.
WARNING!
Pistol has not been cleaned sufficiently
May lead to death or severe injuries and
damage to the pistol
• The pistol must be cleaned after every
shooting session (see Section 7.3).
CAUTION!
Pistol may be damaged
• Sight corrections should only be carried out
on an unloaded pistol by an armourer,
gunsmith or an expert. A special tool (see
Section 6.4) is required for this purpose. Any
corrections should first be carried out on the
rear sight 6.
Fig. 4, Point of impact is on the left