Manual
Service and Repairs
21 06.01GB
8 Pistol service and repairs
8.1 Cause and correction of malfunctions
Pistol maintenance (cleaning and inspection)
according to the instructions can prevent
malfunctions.
Should, nevertheless, a malfunction occur during
shooting, proceed as follows:
Procedure:
1. Remove and safeguard the magazine.
2. Draw back slide 4 to the stop and arrest it in
the open position by thumbing up the slide
catch lever 18.
3. Verify (visually or with a tool) that there is no
bullet, round, case or foreign body in the
chamber or barrel bore (see Fig. 3).
If a projectile is lodged in the bore, strip the
pistol (see Section 7.1) and have the blockage
removed with a suitable tool by a qualified
gunsmith.
4. Remove all rounds, cases or foreign bodies.
Clean, lubricate and assemble the pistol (see
Section 7.3 and 7.4).
5. Have the pistol inspected by an armourer or
gunsmith.
WARNING!
Uncontrolled discharge of shot
May lead to death or severe injuries
• Hold pistol pointed in the firing direction (safe
direction) and keep your finger off trigger
20 while you carry out the operations
described in the following.