Manual

Service and repairs
21 07.02GB
9 Pistol service and repairs
9.1 Cause and correction of malfunctions
Pistol maintenance (cleaning and inspection)
according to the instructions can prevent
malfunctions.
Should, nevertheless, a malfunction occur during
shooting, proceed as follows:
Procedure:
1. Remove and safeguard the magazine.
2. Draw back slide 24 to the stop and arrest it in
the open position by thumbing up the slide
catch lever 8.
3. Verify (visually or with a tool) that there is no
bullet, round, case or foreign grip module in
the chamber or barrel bore (see Fig. 4 on
page 11). If a projectile is lodged in the bore,
strip the pistol (see section “Stripping the
pistol” on page 16) and have the blockage
removed with a suitable tool by a qualified
gunsmith.
4. Remove all rounds, cases or foreign bodies.
Clean, lubricate and assemble the pistol (see
section “Cleaning the pistol” on page 18 and
“Assembling the pistol” on page 18).
5. Have the pistol inspected by an armourer or
gunsmith.
WARNING!
Uncontrolled discharge of shot
May lead to death or severe injuries
• Hold pistol pointed in the firing direction (safe
direction) and keep your finger off trigger 13
while you carry out the operations described
in the following.