Manual

Sight correction

1407.02 GB

7 Sight correction

7.1 Sight correction for windage

7.1.1 Shifting the front sight

Note:

• A special tool (see section “Front sight key” on

page 15) is required for this purpose.

Shifting the front sight 25 by 0.5 mm to the left

alters the point of impact to the right by approx. 8

cm at a 25 m range.

7.2 Sight correction for elevation

Note:

• Any corrections should first be carried out on

the rear sight 26.

7.2.1 Changing the rear sight

Changing the rear sight 26 for a higher one (one

rear sight increment: S to M or M to L) alters the

point of impact by approx. 13,5 cm upwards at a

25 m range.

7.2.2 Changing the front sight

Changing the front sight 25 for a lower one (one

front sight increment) alters the point of impact by

approx. 2.2 cm upwards at a 25 m range.

CAUTION!

Pistol may be damaged

• Sight corrections should only be carried out

on an unloaded pistol by an armourer,

gunsmith or an expert.

Fig. 9, left: when point of impact is on the left; right: when point of

impact is low