Manual

16
USA
17
Maintenance Maintenance
USA
7.2 Cleaning the pistol
• Never clean the barrel from the front and never use
steel brushes, as these can damage the smooth sur-
face of the barrel. Use suitable cleaning rod and brush
of the correct caliber.
• Solvents can damage the surface of the pistol. Before
using a cleaning or solvent agent, take note of the in-
structions and warnings provided by the manufacturer.
Procedure:
1. Moisten cleaning brushes with gun oil and insert into
the barrel through the chamber. Carefully remove all
powder residues and dirt in the barrel and chamber
with the cleaning brush.
2. Free the insides of the barrel bore and chamber of
powder residues and oil using cleaning cloth.
3. Clean external surfaces of the barrel with a brush that
has been moistened with gun oil.
4. Wipe off frame, slide, spring guide and recoil spring
guides with a cloth soaked in gun oil or grease.
5. Lightly oil barrel bore and chamber.
Notice
7.3 Pistol assembly
Procedure:
1. Check there is no foreign matter inside the pistol.
2. Slide recoil spring onto the spring guide.
3. Insert spring guide with recoil spring into the frame.
4. Slip slide over the spring guide (Caution! frame, spring
guide and recoil spring are loosely connected) and pull
back until the slide guide can click into the frame
guide.
5. Pull slide forward in the guide until the slide is in the
locked position.
6. Turn takedown lever by 180° until it points back.
• The pistol is unloaded and decocked.
Notice
7.4 Functional check
The check of all functions must be made on the
assembled pistol:
• to determine any causes of malfunctioning,
• after completion of repairs,
• and after each cleaning and assembly of the pistol.
Procedure:
1. Remove the magazine and unload pistol (see section
4.7 and 4.8).
2. Check tension of the recoil spring and ease of running
of the slide.
• Pull slide back until stop and allow to fly forward.
• Check that the slide flicks forward with energy and
locks into place.
• Repeat check again.
3. Check double action (DA).
• Insert empty magazine (gun has a magazine safety).
• Pull trigger with decocked hammer.
• Check to see if the hammer is cocked and hits home
hard at the end of the trigger path and is then held in
the safety notch.
Notice
Fig. 11
Bolt block
Recoil spring
Magazine
Spring guide
Barrel
Frame