Manual

14
USA
15
Sight Maintenance
USA
6 Sight correction
6.1 Sight correction for windage
Correction on rear sight
Turning the lateral adjusting screw clockwise by one rota-
tion results in a target point differential of 8 cm at 25 m
distance to the left.
Turning the lateral adjusting screw anticlockwise by one
rotation results in a target point differential of 8 cm at
25 m distance to the right.
6.2 Sight correction for elevation
Exchanging the front sight for a lower (higher) one corre-
sponds with a target point differential of 20 cm at 25 m
distance.
Notice
7 Pistol maintenance
• Magazine must be removed from the pistol.
• Before stripping your pistol for cleaning, ensure once
again that it is not loaded (see section 4.7 and 4.8).
• Do not put your fingers into the slide.
7.1 Stripping the pistol
1. Unload pistol (see section 4.7 and 4.8).
2. Pull slide back until stop and hold the slide in the
opened position by pushing up the slide stop lever.
3. Check that there is no round in the chamber.
4. Pushing down the slide stop lever and the slide
forward leave in closed position.
5. Turn takedown lever by 180° until it points forward
(see figure 8).
6. Pull slide right back so that the slide guide can come
out; tilt the slide up and take off towards the front of
the barrel (see figure 9 and 10).
7. Take off complete assembly (slide, spring guide and
recoil spring) via the barrel muzzle.
• This level of stripping is sufficient for a thorough
cleaning after firing.
• Further dismantling of the pistol may only be carried
out by qualified armourers and gunsmiths.
Notice
Warning
Fig. 7
Fig. 8
Fig. 9
Fig. 10
4 16