Manual

Handling
12GB06.01
6.6 Reloading during firing
The slide is held in the open position.
Procedure:
1. Remove the empty magazine.
2. Insert full magazine and ensure that it is fully
engaged.
3. Push slide catch lever down or pull slide back
until stop and allow to fly forward.
– The pistol is loaded and ready to fire.
– The pistol can also be decocked using the
decocking lever.
– The pistol is now loaded, decocked and
ready to fire.
6.7 Unloading the pistol; magazine not
empty
Procedure:
1. Keep the pistol muzzle pointed in a safe
direction.
2. Press the decocking lever; the hammer is held
in the safety notch.
3. Press magazine catch and remove magazine.
4. Pull slide back until stop and push slide stop
lever down. The round is ejected and the slide
is held in the opened position.
5. Check (visually and manually with appropriate
aid) to ensure that the round has been ejected
and that there is no round in the chamber (see
Fig. 6).
6. Press slide catch lever. The slide closes.
7. Push decocking lever down.
8. Empty magazine.
9. Pick up ejected round and clean pistol.
The pistol is unloaded and decocked.
WARNING!
Lacking in awareness of potential dangers
Possibly death or serious injuries
• Never let the pistol out of your hand.
• Keep the pistol aimed at the safe target.
WARNING!
Pistol is ready to fire
Possibly death or serious injuries
• Never let the pistol out of your hand before it
is unloaded.
• The pistol is loaded; a round is in the
chamber.
• Perform the unloading action with only two
fingers from the rear.
• Never place your hand over the slide
opening.