Manual

7
It is the weapon operator’s responsibility to maintain the weapon in a state of
maximum operational readiness. This requires cleaning and lubrication at regular
intervals. Frequent checks by visually and physically verifying the operational state
of the weapon should be performed between maintenance intervals.
CLEANING AND LUBRICATION PROCEDURES continued
Holster and Magazine Pouches
Holster, magazine pouches and ancillary equipment should be inspected
regularly to assure serviceability. Inspect for:
1. Safety/retention devices that retain and release correctly
(snaps, velcro or inserts).
2. Accumulation of lint, dirt, oil, or other foreign material.
3. Overall appearance and shape, inside and outside.
4. Moisture build up.
NOTE: Separate pistol from the holster and magazines from the pouch regularly. This
will help the holster and pouch to dry out and not trap moisture. This also provides an
opportunity for regular visual inspection.
You should use the air hose here (dry air) to blow out pouches and holster. A
clean dry cloth would be sufficient when compressed air is unavailable.
INSPECTION
Be sure that the pistol is safely unloaded ("check twice") before inspection. The following
should be part of that inspection:
Sights
Are they properly configured and positioned correctly?
Do they fit tight on the slide?
Barrel
Is it clean? Barrel and chamber should be inspected for fouling and other firing
residue that may be accumulating.
Is the feed ramp smooth and contoured correctly?
Are there pits inside the barrel? Pits may weaken the metal and allow gas to
escape around the bullet reducing accuracy and velocity.
The crown/muzzle end of the barrel should be inspected for wear, nicks or any
damage that could affect accuracy.