Owner's Manual

5.0 INSTALLING/ REMOVING CO
2
CYLINDER
KEEP FACE AWAY FROM THE CO
2
CYLINDER WHEN REPLACING THE CO
2
CYLINDER.
WEAR GLOVES. ESCAPING CO
2
GAS CAN CAUSE FROSTBITE IF IT COMES IN CONTACT
WITH SKIN.
WHEN REPLACING THE CO
2
CYLINDER, IT IS POSSIBLE THAT SOME RESIDUAL GAS IS
LEFT IN THE CYLINDER. IN ORDER TO AVOID ACCIDENTS, MAKE SURE THAT THE PISTOL
IS UNLOADED AND THE SAFETY IS “ACTIVATED” WHEN REMOVING OR PLACING A CO
2
CYLINDER.
KEEP THE CO
2
CYLINDER AWAY FROM HEAT AND FLAMES. TEMPERATURES OVER 120º
F (50º C) CAN CAUSE EXPLOSION AND INJURY. NEVER THROW A CO
2
CYLINDER INTO
A FIRE. ALWAYS WEAR EYE PROTECTION WHEN HANDLING CO
2
CYLINDER, SINCE
THERE IS A RISK OF INJURY TO THE EYES. DO NOT REMOVE A CO
2
CYLINDER UNTIL IT IS
COMPLETELY EMPTY. FAILURE TO OBSERVE THIS RECOMMENDATION CAN RESULT IN A
DANGEROUS ESCAPE OF RESIDUAL GAS. (REFER TO: SAFE USE AND HANDLING OF CO
2
CYLINDERS SECTION FOR FURTHER INSTRUCTIONS)
7
PULL LEVER DOWN INSERT CO
2
-BOTTOM FIRST CLOSE LEVER
WARNING
M17 Operators Manual for Translation.indd 7 7/3/2018 10:01:23 AM