Owner's Manual

sigsauer.com

This product has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. The equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with these instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this product does cause interference to radio or television reception the user is encouraged

to try to correct the interference by one or more of the following:

• Reorient or relocate the receiving antenna

• Increase the separation between this product and the receiver

• Connect the equipment to an alternative outlet or receiver

• Consult a technician.

CLASS 3R LASER PRODUCT INVISIBLE LASER RADIATION - AVOID DIRECT EYE EXPOSURE

This product complies with IEC 60825-1: 2014-05 Ed 3.0 and complies with FDA performance standards

for laser products except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007.

Po < 20W,

λ = 905 nm, t = 22 ns

DANGER

Shielded interference cable must be used with the equipment in order to comply with the limits for a

digital device pursuant to Subpart B of Part 15 of FCC Rules.

Specifications and designs are subject to change without any notice or obligation on the part of the

manufacturer.

This device complies with part 15 of

the FCC Rules. Operation is subject to the

the following two conditions: (1) This

device may not cause harmful interference,

and (2) this device must accept any

interference received, including

interference that may cause undesired

operation.

• Use of controls or adjustments or performance of procedures other than those specified herein may

result in hazardous radiation exposure. • Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

CAUTION

WARNING

LASER APERTURE