Owner's Manual

60
61
sigsauer.com
Q: My Bluetooth link between my smartphone and my rangefinder keeps disconnecting?
A: You can update your Settings / Preferences from the home screen on your app. Click on the Settings
/ Preferences button in the upper right hand corner of the screen and then change the KILO Timeout
setting to 30, 60 or 180 seconds. This will keep the rangefinder awake longer allowing you to synchronize
and update settings. However, by increasing the KILO Timeout settings this will also force you to wait
longer to put the rangefinder back into Programming Mode. You will have to wait for the rangefinder
to timeout, wake the unit back up by pressing the RANGE button and then pressing and holding down
the MODE button for 2 seconds to re-enter programming mode. Or, alternatively, you can close the Sig
Ballistic App and then enter programming mode if you don’t want to wait for the rangefinder to time out.
If you are still experiencing connection issues make sure you are using the latest version of the Sig
Ballistic App. You can update your app from the App Store or the Google Play store. You may also need
to turn your Bluetooth radio OFF and back ON again to restore the link.
Q: I’m getting a different temperature reading from my rangefinder when I know the
ambient temperature is different?
A: If you are carrying the rangefinder in a pocket or it is sitting in the sun it may sense a different
temperature than the ambient environment. You can either let your rangefinder sit in the shade for a
few minutes or you can override the temperature by entering the Environment sub menu on the app,
touching the KILO icon next to the word “TEMPERATURE” and manually entering the temperature – be
sure to press SYNC to update the temperature on the rangefinder.
Q: My rangefinder is not calculating elevation and wind holds – no holds are showing up on
the OLED display or in the HUD on the app?
A: Your rangefinder is probably set to AMR (Angle Modified Range). In AMR mode only the angle modified
range is displayed on the HUD and on the OLED display. Go into Programming Mode and switch the range
mode from AMR to LOS. Next, select a Profile (i.e. Pro 1). Be sure to have at least one Profile configured
on your app and synchronized with your rangefinder.
Q: My rangefinder is not working. I’ve tried everything but the display will not turn on.
A: It is possible that you have set the display brightness to setting LOW 1. Go into a dark room and press
the RANGE button. You should see the display. Press and hold the MODE button down to enter the
programming mode. Press and release the MODE button until you see the display setting (i.e. Low 1).
Press the RANGE button to select a different setting such as Hi 1 or AUTO. AUTO is recommended as
the display will now automatically adjust to the correct brightness based on your local conditions. Once
selected continue pressing the MODE button until you exit the programming mode.