Owner's Manual

sigsauer.com

5. Environment – From this screen you can adjust your Wind Direction. Wind Direction is the direction

that the wind is coming from. You can override the rangefinder onboard sensors by touching on the

Temperature, Pressure or Humidity data coming from the rangefinder and update any setting. Be sure that

your connection is active and press the SYNC button to synchronize your settings with your rangefinder. In

this example the included WindMETER is reading 11 mph, the Wind Direction is 8:00 and the sensor data is

shown below the wind dial. The temperature setting is now controlled by your smartphone as the KILO icon

has been switched to show that your smartphone is now setting the temperature.

Insert a Note between #5 and #6. Push #6 onto a new page.

After adjusting for wind direction and any

environmental parameters, and verifying

that the rangeﬁnder is connected,

press the SYNC button to update the

rangeﬁnder. You are now ready to range.

Using your ﬁnger you can touch the numbers on the

clock to adjust the Wind Direction. In this case the Wind

Direction is 8:00 and the Wind Heading is 2:00. The wind is

blowing from the 8:00 position towards the 2:00 position.

You can also override the environmental parameters

from this screen. If the outside temperature is low and

the rangeﬁnder has been in your pocket, you may need

to override the temperature setting by selecting the KILO

icon to the left and manually updating the temperature

to the right.

Note - The WeatherFlow WindMETER is included with the KILO8K-ABS. For some smartphones, the

WindMETER will not function properly due to incompatibilities from smartphone to smartphone. This is

caused by insufficient drive current through the audio jack. Some newer smartphones no longer have an

audio jack.

It is recommended that if you have wind measurement issues with the included WindMETER try

downloading the WeatherFlow app to measure your wind speed and then manually input the wind speed

and wind direction within the Sig Ballistic App. Alternatively, using an external Kestrel and then manually

entering your wind speed and direction is also recommended.

If you are having trouble getting wind measurement with the included WindMETER, please remove the

WindMETER, shutdown and relaunch the Sig Ballistic App and manually enter your wind speed and

direction in the app or directly into the rangefinder.