Owner's Manual

sigsauer.com

reset the pairing setting. This feature was implemented to prevent different smartphones from pairing

multiple times to different KILO8K-ABS in case there are multiple units in close proximity. Note – at this

time the KILO8K-ABS will NOT pair with a Kestrel with Bluetooth.

6. Density Altitude – Density Altitude is air density given as a height above mean sea level. Some users

prefer to use DA instead of ballistic holdovers using the embedded AB Elite calculator. DA is OFF by

default. Note - DA is not enabled while using the AB Elite calculator for holdover.

To configure your rangefinder without ballistic holdovers, please follow these steps:

1. Press and release the RANGE button to turn on your rangefinder. You should see the wakeup status

display.

ADVANCED OPERATION (continued)

In each path you can configure the following common features:

1. Target Mode – BEST target will be used in most cases, however, if you are ranging through tall grass or

foliage LAST target mode will suppress close range results and provide the farthest range result.

2. Display Brightness (Lumatic OLED Display) – AUTO will be used in most cases which leverages the

ambient light sensor located in the objective of the rangefinder. This sensor samples the ambient light

conditions and automatically adjusts the display to the local environment. You can change this to 9

individual settings: LOW 1 – 3, MED 1-3 and HI 1-3. Note – if you accidentally leave the unit on Setting

LOW 1 you may not be able to see the display. If this occurs, go into a dark environment and change the

illumination setting.

3. Reticle Select – The center only aiming circle is the simplest aiming reticle which allows for an

uncluttered field of view. You can change the reticle by adding horizontal milling features or both

horizontal and vertical milling features in addition to the center aiming circle. The dots in the grid

represent 5 milliradian increments and the major hash marks represent 10 milliradian increments.

4. Unit of Measure – Y for yards and M for meters.

5. Bluetooth – Your Bluetooth transceiver can be turned ON or OFF. If you have no intention of syncing

custom profiles with the Sig Ballistic App you should turn Bluetooth OFF to reduce power consumption.

Bluetooth is on by default. Note – if you have paired the rangefinder with a smartphone and would like

to pair with a different smartphone you must cycle the Bluetooth transceiver OFF and then ON again to

-----

BEST AMR

Range