Owner's Manual

24
25
sigsauer.com
2. Target Selection (BEST or LAST)
BEST or LAST should be flashing (BEST is the default setting). You can toggle between BEST or LAST
by pressing and releasing the RANGE button. Confirm your selection by pressing and releasing the
MODE button which will save your setting and index to the next setting for configuration. If you do
not press and release the MODE button the rangefinder will save your selection and turn off. BEST
Target can be used for most situations, however, when hunting through foliage or in high grass the
LAST Target is recommended.
3. Display Brightness
Display Brightness (Lumatic OLED Display) – AUTO will be used in most cases which leverages the
ambient light sensor located in the objective of the rangefinder. This sensor samples the ambient
light conditions and automatically adjusts the display to the local environment. You can change this
to 9 individual settings: LOW 1 – 3, MED 1-3 and HI 1-3. Note – if you accidentally leave the unit on
Setting LOW 1 you may not be able to see the display. If this occurs, go into a dark environment and
change the illumination setting.
4. Reticle Select
After selecting and saving display brightness, the rangefinder will then index to the next
programming mode which is Reticle Select. You can select between center aiming circle only, or add
the horizontal milling grid or add both the horizontal and vertical milling grid. You can confirm your
selection by pressing and releasing the MODE button – which will cause Reticle to stop flashing and
confirm your selection.
5. Unit of Measure Selection (Y or M)
Your current selection will be flashing (Yards is default). You can toggle between Y or M by pressing
and releasing the RANGE button. Confirm your selection by pressing and releasing the MODE button
which will save your setting and index to the next setting for configuration. If you do not press and
release the MODE button the rangefinder will save your selection and turn off.
6. Ballistic Group Selection
Your current selection will be flashing (grP1 is default). You can toggle between a custom ballistic
profile (APP) configured using the BDX App or one of the 8 ballistic groups by pressing and releasing
the RANGE button. Confirm your selection by pressing and releasing the MODE button which will