Owner's Manual
22
23
sigsauer.com
CHANGING MODES OF OPERATION
The rangefinder ships with the most common modes already configured. However, you can access
and change the following features:
• Line of Sight (LOS), Angle Modified Range (AMR) or Applied Ballistics Ultralight (ABU)
• Best or Last Target
• Display Brightness (AUTO + 3 Low, 3 Medium and 3 High)
• Reticle Select (Center Circle, Horizontal Grid, or Horizontal and Vertical Grid)
• Units of Measure (Y or M)
• Ballistic Group Selection (Centerfire Groups 1-6, Muzzleloader Group 7 and Crossbow Group 8).
• Initiate QuickBOND (On or Off)
RANGEFINDER CONFIGURATION – PROGRAMMING SEQUENCE
Note – the rangefinder can more easily be programmed and configured by using the
free Sig BDX App.
1. Mode Selection (AMR, LOS or ABU)
To enter programming mode, press and release the RANGE button to wakeup the rangefinder.
Once the display is visible, press and hold the MODE button for 2 seconds – then release the MODE
button and the current selection will be flashing (AMR is the default setting). You can switch
between AMR, LOS or ABU by pressing and releasing the RANGE button. Confirm your selection by
pressing and releasing the MODE button which will save your setting and index to the next setting
for configuration. If you do not press and release the MODE button the rangefinder will save your
selection and turn off. If the user intends to use a calculated ballistic solution, the rangefinder must
be in ABU mode. Instructions for downloading and configuring the BDX App on your smartphone will
be detailed later in the instructions.