Owner's Manual

PAIRING A KESTREL 5700 ELITE WITH THE KILO3000BDX

Using the RANGE / MODE buttons or the BDX App, put the KILO in ABE/ABX mode. This allows

the KILO to be seen by the Kestrel. ABE will be displayed in the KILO. AB External will be

displayed in the App. Close the BDX App.

Next, turn on your Kestrel. Follow the instructions for the Kestrel to turn on the Bluetooth

radio and connect devices to the Kestrel (https://kestrelinstruments.com/support/manuals-and-

downloads). On the Kestrel, open the Options Menu and select BLUETOOTH, set BLUETOOTH ON.

Next, set CONCT to DEVICE. Then, scroll down and select the KILO - the KILO must be turned on

and in ABE/ABX mode. You should see K3000BDX-12345 listed on the Kestrel. Select and exit

the menu.

Your Kestrel is now paired to your KILO. Note - the BDX App will no longer work properly when

a Kestrel is actively paired to the KILO. However, if your KILO was previously paired and bonded

with a SIERRA3 or other BDX enabled sight this link will be maintained.

When actively paired with the Kestrel you will now be able to range targets and receive accurate

ballistic holdover solutions displayed on the Kestrel and within the KILO.