Owner's Manual

sigsauer.com

2. Target Selection (BEST or LAST)

BEST or LAST should be flashing (BEST is the default setting). You can toggle between BEST or LAST

by pressing and releasing the RANGE button. Confirm your selection by pressing and releasing the

MODE button which will save your setting and index to the next setting for configuration. If you do

not press and release the MODE button the rangefinder will save your selection and turn off. BEST

Target can be used for most situations, however, when hunting through foliage or in high grass the

LAST Target is recommended.

3. Display Brighness

Display Brightness (Lumatic OLED Display) – AUTO will be used in most cases which leverages the

ambient light sensor located in the objective of the rangefinder. This sensor samples the ambient

light conditions and automatically adjusts the display to the local environment. You can change this

to 9 individual settings: LOW 1 – 3, MED 1-3 and HI 1-3. Note – if you accidentally leave the unit on

Setting LOW 1 you may not be able to see the display. If this occurs, go into a dark environment and

change the illumination setting.