Owner's Manual

sigsauer.com

This product has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. The equipment generates, uses and can radiate radio frequency energy and,

if not installed and used in accordance with these instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation.

If this product does cause interference to radio or television reception the user is encouraged to try to

correct the interference by one or more of the following

CLASS 1M LASER PRODUCT. INVISIBLE LASER RADIATION. DO NOT VIEW DIRECTLY WITH

OPTICAL INSTRUMENTS (BINOCULARS OR TELESCOPES).

This product complies with IEC 60825-1: 2014-05 Ed 3.0 and complies with FDA performance standards for

laser products except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007.

FCC ID:2AP8SK10K IC:24032-K10K

P p < 41.4W, λ = 905 nm, t = 22 ns

DANGER

• Reorient or relocate the receiving antenna

• Increase the separation between this product and the receiver

• Connect the equipment to an alternative outlet or receiver

• Consult a technician.

Shielded interference cable must be used with the equipment in order to comply with the limits for a digital

device pursuant to Subpart B of Part 15 of FCC Rules.

Specifications and designs are subject to change without any notice or obligation on the part of the

manufacturer.

LASER APERTURE

Use of controls or adjustments or performance of

procedures other than those specified herein may

result in hazardous radiation exposure. Changes or

modifications not expressly approved by the party

responsible for compliance could void the user’s

authority to operate the equipment.

CAUTION

41.4

FCC ID:2AP8SK301M

IC:24032-K301M