Owner's Manual

46
47
sigsauer.com
Q: When using AB External on my KILO I can no longer see the rangefinder information on the HUD in the BDX
App.
A: If your KILO and a Kestrel are actively paired (sending / receiving information) the BDX App cannot be
connected and paired to your KILO at the same time.
Q: My KILO is set to AB External but isn’t displaying holdover information.
A: To display a complete ballistic solution your KILO must be actively paired with a Kestrel. No holdover
information is displayed unless the Kestrel and KILO are both on and actively paired.
Q: The rangefinder HUD in the BDX App is sluggish when using my KILO in AB External mode (Kestrel is not
paired to the KILO)
A: AB External mode on your KILO was designed to be used directly with a Kestrel with AB Elite on board.
This communications protocol is relatively slow and does not respond quickly as compared to using AB
Ultralight. AB Ultralight resides on your KILO and is much faster for calculating ballistic solutions out to 800
yards.
Q: My KILO and Kestrel are paired but I am not getting anything but zero’s for elevation and wind holds.
A: You need to setup at least one custom bullet profile on your Kestrel. See the Kestrel instructions for
setting up a bullet profile.
This page intentionally left blank.