Owner's Manual

sigsauer.com

RANGEFINDER CONFIGURATION – PROGRAMMING SEQUENCE

Note – the rangefinder can more easily be programmed and configured by using the

free Sig BDX App.

1. Mode Selection (AMR, LOS, ABU or ABE/ABX)

To enter programming mode, press and release the RANGE button to wakeup the rangefinder. Once

the display is visible, press and hold the MODE button for 2 seconds – then release the MODE button

and the current selection will be flashing (AMR is the default setting). You can switch between

AMR, LOS, ABU or ABE/ABX by pressing and releasing the RANGE button. Confirm your selection by

pressing and releasing the MODE button which will save your setting and index to the next setting

for configuration. If you do not press and release the MODE button the rangefinder will save your

selection and turn off. If the user intends to use a calculated ballistic solution, the rangefinder must

be in ABU or ABE/ABX mode. Instructions for downloading and configuring the BDX App on your

smartphone will be detailed later in the instructions.

2. Target Selection (BEST or LAST)

BEST or LAST should be flashing (BEST is the default setting). You can toggle between BEST or LAST

by pressing and releasing the RANGE button. Confirm your selection by pressing and releasing the

MODE button which will save your setting and index to the next setting for configuration. If you do

not press and release the MODE button the rangefinder will save your selection and turn off. BEST

Target can be used for most situations, however, when hunting through foliage or in high grass the

LAST Target is recommended.

3. Display Brightness

Display Brightness (Lumatic OLED Display) – AUTO will be used in most cases which leverages the

ambient light sensor located in the objective of the rangefinder. This sensor samples the ambient

light conditions and automatically adjusts the display to the local environment. You can change this

to 9 individual settings: LOW 1 – 3, MED 1-3 and HI 1-3. Note – if you accidentally leave the unit on

Setting LOW 1 you may not be able to see the display. If this occurs, go into a dark environment and

change the illumination setting.