Owner manual

10
4. Assembling, taking down
WARNING:
Make sure there are no cartridges in
the chamber or magazine.
4.1 Assembling
• Remove the large allen key (SW 4)
from its pocket in the shipping carton.
With the barrel screw studs pointing
down, insert the barrel into the receiv-
er (fig. 1).
fig. 1 fig. 2
fig. 3
• Then, insert the allen key into the holes
on the bottom of the fore-end and
tighten the two allen screws equally
locking the barrel and receiver together
(fig. 2).
NOTE:
Do not use any extension tools on the
allen key to tighten screws. Good hand
tightness is sufficient.
• Insert the magazine from the bottom
into the receiver until both magazine
releases are engaged (fig. 3).
R-93-LRS_2 6/8/01 2:32 PM Page 10