Manual
2. Periodically remove and clean the choke tubes. Place a light film of gun
grease on the threads. Clean the internal threads with the nylon thread-clean-
ing end of the choke tube wrench.
3. Remove any residue from the exposed monoblock section including pivot pin
recesses and the ejector assembly. Then lightly coat these parts with a quality
gun oil preservative, wiping off any excess with a clean cloth.
4. Place a thin film of high-pressure gun grease on the inside of the
pivot pin recesses.
5. Coat the entire outer surface of the barrels with a quality gun oil preservative
and wipe off any excess. Note: Do not over lubricate any parts of your
firearm.
Forend Assembly:
1. Clean off any dirt or powder residue from the metal parts.
2. Coat the metal parts with a thin film of quality gun oil.
3. Wipe off forend with a clean dry cloth.
Repair and Servicing
Although your Aurora Series shotgun has been precision manufactured and
assembled from the highest quality materials, there is always the possibility of
damage or the need for servicing and/or parts replacement. If you suspect your
shotgun might be damaged, or if you ever experience any malfunction or notice
any looseness in the action of your shotgun, stop using it immediately. Return it
to SIGARMS
â„¢
for inspection and any necessary repair.
Ordering Parts
Before you order any parts, please be advised that, while most gunsmiths may
be perfectly capable of repairing your shotgun, we do not vouch for any individual’s
skill or workmanship. Remember, unauthorized adjustments or parts replacement
can void your service warranty. Your Aurora Series shotgun is a precision instru-
ment and replacement parts require a trained gunsmith to ensure proper installa-
tion and operation. Remember to always specify the model and serial number of
your shotgun when ordering parts. The most sensible decision you can make if
your shotgun needs servicing is to simply return it to the SIGARMS
Service Department.
Serial Number:
The serial number of your new Aurora Series shotgun is located on the top of
the receiver tang, under the top lever in the closed position. Record the serial num-
ber here for future reference. Aurora Serial #___________________________
13