Manual

Normal Operation

Before attempting to shoot your Aurora Series shotgun, be sure that it is cor-

rectly assembled, that choke tubes are correctly and snugly installed, and the

barrel is free of obstructions.

Loading:

1. To load your Aurora Series shotgun , set the safety switch to “ON” (SAFE) and

set the barrel selector button to the barrel you wish to fire first.

2. Unlock the action by pushing the top lever to the right and open it by put-

ting downward pressure on the barrels.

3. When loading, always point the barrels in a safe direction. Insert one or two

shotshells. If you are loading just one shotshell, make sure the barrel selec-

tor is positioned to fire that barrel.

4. Keeping your finger off the trigger, close the action by exerting upward

pressure on the barrels until the top lever snaps back into the locked posi-

tion.

5. Keep the safety in the rear, “ON” (SAFE) position until you are ready to

fire, then push it forward to “OFF” (FIRE).

6. If you pull the trigger and the gun does not fire, keep it pointed in a safe

direction and wait 30 seconds. Then, open the action carefully, remove and

examine the loaded shotshells. If the shotshell primer is dented but did not

fire, do not reuse the shotshell. If the primer is not dented, check to see if

the barrel selector is set correctly for the proper barrel. If the firearm still

fails to fire, contact SIGARMS

™

7. If you experience a light or “squib” load, always check to make sure the

barrels are clear of any obstruction before reloading.

8. After firing, push the top lever to the right and open the action all the way

until the automatic ejectors eject the one or two fired shotshells.

9. If you do not reload immediately, are leaving a hunting field, or walking off

a clay target stand, leave the action visibly open for both your safety and

the well-being of your shooting companions.