User's Manual

7
SMAC3 User Material
1.3
Professional Antenna Installation Instructions
Installation Personal
This product is designed for specific application and needs to be installed by a qualified
personal who has RF and related rule knowledge. The general user shall not attempt to install
or change the setting. For complete RF test reports and regulatory power limits, please see
documents under FCC-ID: Q5A-SMAC-5700
Installation Location
The product shall be installed at a location where the radiating antenna can be kept 165cm
from nearby person in normal operation condition to meet regulatory RF exposure
requirement.
External Antenna
Use only the antennas which have been approved in section Certified Antennas. The non-
approved antenna(s) may produce unwanted spurious or excessive RF transmitting power
which may lead to the violation of FCC limit and is prohibited.
Warning
Please carefully select the installation position and make sure that the final output power does not exceed
the limit set force in relevant rules. The violation of the rule could lead to serious federal penalty.
It is the responsibility of the installer to ensure that when configuring the radio in the United States (or
where FCC rules apply), the Tx power is set according to the values for which the product is certified. The
use of Tx power values other than those, for which the product is certified, is expressly forbidden by FCC
rules 47 CFR part 15.204.
It is the responsibility of the installer to ensure that when using the outdoor antenna kits in the United
States (or where FCC rules apply), only those antennas certified with the product are used. The use of any
antenna other than those certified with the product is expressly forbidden by FCC rules 47 CFR part 15.204.