User's Manual

SMAC3 User Material

6.5.3 Reset

To Reset, Click Management > Upgrade/ Reset> Reset

This option allows user to reset all device configuration to factory defaults.

After reset, the device has to be accessed using the LAN interface locally and has to

be re-configured to allow the device to join into the network again.

Retain IP: If Retain IP is checked, the last IP before the reset will be recalled.

7 Monitor

7.1 Statistics

The objective of statistics page is to allow an administrator to view the state of wired and

wireless interfaces. These statistics assist the network administrator to troubleshoot the

devices.

7.1.1 5 GHz Radio:

You can view the details of associated devices connected to the 5 GHz Radio.

To view the 5 GHz Radio Statistics, click Monitor > Statistics > 5 GHz Radio

 MAC Address: Displays the MAC address of the linked remote device

 IPv4-Address: Displays the IP address of the remote device

 Link Id: Displays the link Id of remote device

 Distance (Km): Displays the distance between the AP and SU.

 Local Signal (dB): Displays the local signal strength

 Remote Signal (dB): Displays the Signal strength of the remote device

 Rate (Mbps): Displays the Transmit (Tx) and Receive (Rx) rate of a al device

 Throughput (Mbps): Displays the current Input and Output bandwidth