User's Manual

18
SMAC3 User Material
3 Quick Start
3.1 System
3.1.1 IP configuration
To configure the IP Configuration, Click Quick Start> System
Address Type: Dynamic / Static
 If Static is selected, the user should manually configure the network parameters.
 If Dynamic is selected, the device obtains the IPv4 parameters from a DHCP server
automatically. According to the current software release, only IPv4 format is supported.
IP Address: 192.168.1.1
 Represents the IP Address of the Ethernet interface
 By default, the Static IP address is set to 192.168.1.1
 When the Address Type is set to Dynamic, this parameter is read-only and displays the device
IP Address obtained from the DHCP server.
Subnet Mask: 255.255.255.0
 Subnet Mask Represents the subnet mask of the Ethernet interface.
 By default, the subnet mask is 255.255.255.0.
 When the address type is set to
Dynamic, this parameter is read-only
and displays the device current
subnet mask obtained from the
DHCP server.
 The subnet mask will fall back to
255.255.255.0 if the device cannot
obtain the subnet mask from the
DHCP server.
Gateway IP:
 Specifies the IP address of the
device gateway
 When Address Type is set to
Dynamic, this parameter is read-only and displays the IP address of the device gateway. The
device will be set to the Default Gateway IP address 192.168.1.1 if it cannot obtain the
Gateway IP address from a DHCP server.

If the Address Type is set to Static then you have to enter manually the Gateway IP address.