User's Manual

16
SMAC3 User Material
Super user
 In case of accessing AP, the Super user has a read-only option, where he cannot create,
modify or delete any parameters.
 In case of accessing SU, the Super user has read-only permission, but made few
custom- limited read-write permissions for parameters such as Ethernet Speed, VLAN
modes (Transparent and Access), Filtering, Traffic shaping, and Device Reboot.
User
While accessing AP and SU devices, the user has read-only permission, where he cannot
create, modify or delete any parameters.
Installer
The installer does not have full access to Access Point or Subscriber Unit, but he has read-
write permission for a few parameters such as IP configuration, Location parameters, and
Radio mode. The installer also can view site survey scan results (to join any AP) and observe
the link statistics status.
2.5 Quick Configuration
This section will show you how to do a quick configuration for both the outdoor Access Point
and Subscriber Units using a web-based configuration interface.
Please refer Devices Access Types or use your Ethernet port or wireless network to access
the AP/ SU and proceed.
After connecting via any one of the three-device access methods, the GUI will prompt you
to login with a password. The default username and password is "admin", and should be
changed immediately after login to protect your network since it gives the user read - write
privileges.
The password can be changed:
Click Management > Services> HTTP > Admin password/ User / Super User/ Installer
Password.
Web Configuration
 Launch any web browser on the PC that is connected to the device.
 In the URL type 192.168.1.1 and enter default credentials as user name: admin and
password: admin
 Login and access the device settings in the GUI