TDS

ManualsBrandsSIEVERT ManualsTools14.1 oz. MAPP Gas Cylinder, 1 in. Valve, No Regulator Required

Sievert MAPP Gas

Safety Data Sheet

according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations

Issue date: 08/19/2021 Version: 1.0

08/19/2021

Sievert MAPP Gas

Page 1

SECTION 1: Identification

1.1. Identification

Product form

Mixture

Product name

Sievert MAPP

1.2. Recommended use and restrictions on use

Recommended use: Welding and brazing.

Restrictions on use: Any use other than the above identified.

1.3. Supplier

Rothenberger USA, Inc.

7130 Clinton Road

Loves Park, IL 61111 - USA

T 800-545-7698

1.4. Emergency telephone number

Emergency number

ChemTel – Domestic: 1-800-255-3924, International: +1-813-248-0585

Contract number: MIS9223846

SECTION 2: Hazard(s) identification

2.1. Classification of the substance or mixture

GHS-US classification

Flammmable Gas – Category 1A

H220

Gas Under Pressure – Liquified Gas

H280

2.2. GHS Label elements, including precautionary statements

GHS US labelling

Hazard pictograms (GHS US)

Signal word (GHS US)

Danger

Hazard statements (GHS US)

H220 - Extremely flammable gas.

H280 - Contains gas under pressure; may explode if heated.

Precautionary statements (GHS US)

P210 - Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No

smoking.

P377 - Leaking gas fire: Do not extinguish, unless leak can be stopped safely.

P381 – In case of leakage, eliminate all ignition sources

P403 - Store in a well-ventilated place.

P410+P403 - Protect from sunlight. Store in a well-ventilated place.

2.3. Other hazards which do not result in classification

Other hazards which do not result in

classification

Physico-chemical: The product may form explosive mixtures with air, especially in confined

spaces. Vapors are heavier than air and may accumulate at or below ground level. A strong

heating of the cylinder (e.g., in case of fire) causes a relevant increase in volume of the liquid

and pressure, with the risk of bursting.

Human health: The accumulation of the product - especially in confined spaces - may cause

asphyxiation due to lack of oxygen. The contact with liquid may cause serious frostbite injuries

to the skin and eyes.

Environment: The product does not meet criteria for PBT or vPvB classification according to

Annex XIII of Regulation (EC) 1907/2006 (REACH).

2.4. Unknown acute toxicity (GHS US)

Not applicable

SECTION 3: Composition/information on ingredients

3.1. Substances

Name

Product identifier

Propene

(CAS-No.) 115-07-1

100

Summary of content (9 pages)

PAGE 1
Sievert MAPP Gas Safety Data Sheet according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations Issue date: 08/19/2021 Version: 1.0 SECTION 1: Identification 1.1. Identification Product form : Mixture Product name : Sievert MAPP 1.2. Recommended use and restrictions on use Recommended use: Welding and brazing. Restrictions on use: Any use other than the above identified. 1.3. Supplier Rothenberger USA, Inc.
PAGE 2
Sievert MAPP Gas Safety Data Sheet according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations 3.2. Mixtures Not applicable SECTION 4: First-aid measures 4.1. Description of first aid measures First-aid measures general : If exposed or concerned, get medical attention/advice. Show this safety data sheet to the doctor in attendance. Wash contaminated clothing before re-use. Never give anything to an unconscious person.
PAGE 3
Sievert MAPP Gas Safety Data Sheet according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations SECTION 6: Accidental release measures 6.1. Personal precautions, protective equipment and emergency procedures General measures 6.1.1. : Evacuate area. Keep upwind. Ventilate area. Spill should be handled by trained cleaning personnel properly equipped with respiratory and eye protection.
PAGE 4
Sievert MAPP Gas Safety Data Sheet according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations Storage conditions : The product is subject to the provisions of Directive 2012/18/EU (SEVESO III) as a flammable gas (P2). The electrical equipment present in the storage area must be compatible with the risk of forming explosive atmospheres. Store the cylinders in a vertical position and anchored in order to prevent their fall.
PAGE 5
Sievert MAPP Gas Safety Data Sheet according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations Handle the product only in closed systems. Provide local exhaust ventilation suction or other devices to maintain the levels of particles in the air below the recommended exposure limits. In the event that a release of flammable gases or vapors may occur, provide for the use of appropriate detectors.
PAGE 6
Sievert MAPP Gas Safety Data Sheet according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations 10.4. Conditions to avoid Avoid sunlight, heat, flames, high temperatures, sparks, static electricity and other sources of ignition. Avoid contact with incompatible materials. 10.5. Incompatible materials Oxidizing agents. 10.6. Hazardous decomposition products Under normal conditions of storage and use, hazardous decomposition products should not be produced.
PAGE 7
Sievert MAPP Gas Safety Data Sheet according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations 12.3. Bioaccumulative potential Sievert MAPP Gas Log Pow Bioaccumulative potential 12.4. Mobility in soil Sievert MAPP Gas Henry's law constant Mobility in soil 12.5. 1.77 This material is not expected to bioaccumulate. 1.099 MPa (25 °C) Due to the high volatility, the product is not expected to cause pollution of soil and groundwater.
PAGE 8
Sievert MAPP Gas Safety Data Sheet according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations Class (ADR/RID) : 2 - Gases Limited quantities (ADR/RID) : 0 Classification code : 2F Hazard identification number : 23 Tunnel Restriction code : B/D Limited quantities : 0 Exempted quantities : E0 Packing instructions : P200 Transport by sea (IMDG) Transport document description (IMDG) : UN 1077 PROPYLENE, 2.1 UN-No.
PAGE 9
Sievert MAPP Gas Safety Data Sheet according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations NFPA health hazard : 1 - Materials that, under emergency conditions, can cause significant irritation. NFPA fire hazard : 4 - Materials that rapidly or completely vaporize at atmospheric pressure and normal ambient temperature or that are readily dispersed in air and burn readily.