Installation guide

Troubleshooting the SIERRA™ plus film digitizer 1-73
VIDAR Film Digitizer Installation Guide
Managing power
Applying and removing power
WARNING
Do not apply power by plugging the DC power connector into
the digitizer while the power supply is live. Do not remove
power by unplugging the DC power connector from the digitizer
while the power supply is live. Either of these actions could
permanently damage the digitizer, the power supply or both.
Note:
Sierra was designed to be powered continuously. Under
normal conditions, the digitizer should remain on at all times.
Use only the AC power cord to turn the digitizer on or turn it off, as
shown here:
Always connect the DC power connector before applying power. Do not
disconnect the DC power connector until after power is removed.