Installation guide

Troubleshooting the SIERRA™ plus film digitizer 1-71
VIDAR Film Digitizer Installation Guide
How to reset the digitizer
RECOMMENDED RESET procedure
1. Locate the switch-adjusting tool.
(If the tool is not available, you may use a non-conductive rod having
a 1/8" or smaller diameter.)
WARNING
Never insert metal or conductive items into the digitizer.
2. Insert the tool’s hex tip into the hole located in the center of the
mounting bracket, then press gently on the Reset button inside the
digitizer.
3. The digitizer will perform its calibration.
4. Wait until the digitizer’s LED shows solid green.
5. Reboot the PC.
For clarity, the digitizer, exit tray and other
details have been omitted from this figure
Hex tip of
switch adjusting tool
Reset switch