Installation guide

Installing SCSI software for the SIERRA™ plus film digitizer 1-51
VIDAR Film Digitizer Installation Guide
Apply power: digitizer first, then PC
1. Assure the PC is turned off.
Note:
Always apply power to the digitizer before turning on the
computer. This enables the computer to recognize the digitizer.
2. Connect the digitizer’s electrical power cord (connected to the power
supply) to an electrical outlet.
Note:
The film digitizer does not have a power switch.
3. Observe the LED on the front of the digitizer: the LED should flash
yellow for several minutes. This indicates the digitizer is performing
internal tests.
4. When the LED stops flashing and remains green, turn on the PC.
5. Go to the section in this chapter that matches your computer’s
operating system.