Installation guide

Wall mounting the SIERRA™ plus film digitizer 1-43
VIDAR Film Digitizer Installation Guide
9. Install the entrance tray.
a. Hold the entrance tray with the wheels away from you, and the top
tilted toward you.
b. Slide one tip into the hole in the digitizer as far as it will go.
c. Slide the other tip into the opposite hole.
d. Center the entrance tray, then push its top gently back until the tray
fits against the digitizer (see below right), between the two centering
guides. Snap the retaining clip over the upper edge of the digitizer
body.
Centering
guide (1 of 2)
After inserting tabs
into digitizer, push
feed tray gently
into position...
then snap retaining
clip over body