Installation guide

Wall mounting the SIERRA™ plus film digitizer 1-38

VIDAR Film Digitizer Installation Guide

5. Route and connect the power cable.

a. Locate the power supply. Identify the power cable

(permanently attached to the power supply) and

the power connector at its end.

WARNING:

Do not connect the AC power

cord at this time.

b. About 10 inches (25cm) from the end of the power

cable form a partial loop (see below left).

c. Insert the loop into the rectangular hole in the bottom of the mounting

bracket, and slide it into the cutouts toward the front (below, left, #1).

Note:

Make sure the power cable is clear of the rectangular

hole and doesn’t block the SCSI connector.

d. Plug the end of the power cable into the jack near the right end of the

mounting bracket (below, left, #2).

IMPORTANT:

Never force the power connector. If you have

difficulty attaching the power connector, assure that the

digitizer’s power jack is aligned with the mounting bracket hole.

To power supply

For clarity, the digitizer and other details

have been omitted from these figures





SIERRA