Installation guide

Wall mounting the SIERRA™ plus film digitizer 1-37
VIDAR Film Digitizer Installation Guide
4. Mount the digitizer.
a. Locate the four mounting slots on the back of the digitizer. These
slots match the four tabs on the mounting bracket.
b. Position the digitizer so its front is facing you (VIDAR logo is
visible).
c. Grasp the digitizer by its sides.
d. Slide the digitizer’s upper mounting slots over the upper tabs on the
mounting bracket (as shown below left). Assure that the slots drop
into the notches in the tabs.
e. Rotate the bottom of the digitizer toward the wall, so the bottom
mounting slots slide over the bottom tabs on the mounting bracket (as
shown below center).
Note:
When the digitizer is properly mounted, its rear panel is
in full contact with the grounding springs on the bracket.
Hook top slots over top tabs... then slide bottom slots over bottom tabs
Digitizer
Mounting bracket
Lower plastic foot should extend
slightly beyond mounting bracket
Back of digitizer should be
parallel to mounting bracket