Installation guide

Table-top stand for the SIERRA™ plus film digitizer 1-28
VIDAR Film Digitizer Installation Guide
9. Install the entrance tray film guide assembly.
Note:
Skip this step if you are installing a single film unit.
a. Grasp the upper housing in one hand.
b. Hold the upper housing so that its foam wheels are
slightly to the left of the wheels on the entrance tray.
c. Grasp the lower housing with the other hand and tilt its
bottom edge toward you.
d. Slide the metal clip in the back of the lower housing
into the film feed slot and position the clip’s slot over
the rib inside the digitizer body.
e. Press the lower housing downward until it snaps in
place.
f. Check wheel alignment: the wheels in the film guide
assembly should now be aligned with the wheels on
the entrance tray.