Installation guide

Table-top stand for the SIERRA™ plus film digitizer 1-23
VIDAR Film Digitizer Installation Guide
5. Connect the SCSI cable.
Note:
Before connecting the SCSI cable, be certain that the
SCSI cable isn’t connected to anything else and the digitizer
power supply is unplugged.
a. Locate the SCSI cable.
b. Orient the SCSI connector as
shown here. 
c. Carefully attach the SCSI connector to the digitizer’s SCSI port
connector (located inside the rectangular hole in the mounting
bracket). Apply even pressure to avoid bending SCSI connector pins.
Do not force the connectors together.
WARNING:
If the SCSI connector has bent pins, it will damage
the SCSI port in the digitizer. Do not attempt to straighten bent
pins. Discard any SCSI cable with bent pins and replace it with
a new cable.
For clarity, the digitizer and other details
have been omitted from this figure
SCSI cable
and connector
Toward rear of digitizer