Installation guide

Table-top stand for the SIERRA™ plus film digitizer 1-21
VIDAR Film Digitizer Installation Guide
3. Mount the digitizer.
a. Locate the four mounting slots on the back of the digitizer. These
slots match the four tabs on the mounting bracket.
b. Position the digitizer so its front is facing you (VIDAR logo is
visible).
c. Grasp the digitizer by its sides.
d. Slide the digitizer’s upper mounting slots over the upper tabs on the
mounting bracket (as shown below left). Assure that the slots drop
into the notches in the tabs.
e. Rotate the bottom of the digitizer toward the mounting bracket, so the
bottom mounting slots slide over the bottom tabs on the mounting
bracket (as shown below center).
Note:
When the digitizer is properly mounted, its rear panel is
in full contact with the grounding tabs on the bracket.
Digitizer
Mounting bracket
Lower plastic foot should extend
slightly beyond mounting bracket
Back of digitizer should be
parallel to mounting bracket
Hook top slots over top tabs... then slide bottom slots over bottom tabs