Installation guide

Table-top stand for the SIERRA™ plus film digitizer 1-19
VIDAR Film Digitizer Installation Guide
2. Assemble the stand and mounting bracket.
Tip:
It’s easiest to assemble the mounting bracket to the stand
while the stand is on its back, as shown on the next page.
a. Insert the “U” tube into both leg tubes. All rubber feet should be on
the same side (see next page). Secure the “U” tube with two 8-32 x
3/8" screws. Do not tighten the screws yet.
b. Secure the mounting bracket to the plates on the legs with four 8-32
x 3/8" screws. The diagram below shows which holes to use.
c. Tighten all screws.
d. Place the stand on its feet.