Installation guide

Configuring SCSI settings for the SIERRA™ plus film digitizer 1-14
VIDAR Film Digitizer Installation Guide
To change the digitizer’s SCSI termination:
Note:
The SIERRA™ plus is shipped from VIDAR with the
SCSI termination switch set to
internal termination on
.
a. Lay the digitizer on its back, with its bottom surface toward you.
b. Locate the SCSI termination switches on the bottom of the digitizer.
c. To deactivate SCSI termination, slide
Switch 1 to position shown using the
flat tip of the switch-adjusting tool.
(Switch 2 has no function.)
SCSI termination switches
12
12
Switch 1 set
for no internal
termination
Switch 1 set
for internal
termination